Audio technica at2020 usb bundle pro#
The AT2035 sounds flatter than the AT2020 and this is always a pro since it gives you the option to better tweak everything in post. When mic’ing up guitar cabinets, on the other hand, I found it to sound a bit muddy, but this isn’t anything that can’t be fixed in post by adding a high-pass filter, or even by engaging the one on the mic, so no worries there. Voice-related, as well as when recording acoustic guitars. It sounds great when recording vocals or doing anything The sound quality is much better than the AT2020 in my opinion. Scarlett 6i6 vs UMC 404HD (A bit more expensive but very cost-efficient).Scarlett 2i2 vs UMC204HD (Higher quality and affordable).Here’s a list of posts I wrote about great and budget-friendly audio interfaces: Here’s a post about two very inexpensive Audio Interfaces, however I’d recommend going with something a little more powerful. Most Audio Interfaces are super affordable though and you can even get some pretty good ones for under $70.
Now, I’ve read on some websites that you don’t really need an Interface to be able to use the AT2035 or the AT2035, and while you could certainly use a phantom power supply and then connect the mic to your computer via an XLR/TRS mini cable, it’s not the ideal way since the analog to digital conversion will be done by your PC’s soundcard instead of a dedicated audio interface. Requires 48v of phantom power while the AT2035 requires 11-52v. Now, here’s another point where both these mics differ The AT2020 Microphone, which means that it is going to need phantom power in order to work properly. Just like the AT2020, The AT2035 is a cardioid condenser Other than that, both the AT2035 and the AT3035 are the The only differences are a couple of the electronics and the color of the mics themselves, AND that the AT3035 used to sell for around $350! The shock mount, which comes included is made out of plastic but it gets the job done and it’s also very durable, so no worries there.Īpparently, the AT2035 is modelled after the AT3035 (A mic which I currently Own and that just sounds fantastic), which has now been discontinued. This means that you won’t need to drive the preamps on your Interface as much, yielding a cleaner signal, and it also has a lower self-noise. Notice that it has a louder output signal. Not only that, but when looking at the sensitivity you’ll One difference between the AT2020 and this one is that it comes with a -10dB PAD as well as a high-pass filter. The body and the grille are all metal and it really does Just like all the other AT20’ series, the AT2035 has a great Build quality, pretty much identical to the one of the AT2020. Audio-Technica AT2020: Amazon, Sweetwater.Cardioid polar patter which reduces the overall noise picked upįind out more about the Audio-Technica AT2020 here:.High SPL handling and wide dynamic range provide maximum versatility.The slight boost to the mid-high frequencies can actually help your vocals better cut through the mix, but again, this is something you can do with EQ later on.Īll in all, it’s a terrific mic to get if you’re on a budget! What comes in the box?
Audio technica at2020 usb bundle plus#
It has a slightly reduced low-end which I personally don’t like for the simple fact that ends up lacking a bit of “body”, plus I prefer to control this in post later on with EQ. The recording quality is great, especially since this It has a frequency response of 20Hz-20kHz which is standard for almost every large diaphragm condenser microphone out there.
This is essential because you want to avoid picking up unwanted noises andĪny of the room’s natural sound, and a cardioid pattern will help with this Will mostly be picking up sound from the front while rejecting sound Since the Audio-Technica AT2020 has a Cardioid pickup pattern, it
Recording music, doing voice-over work, streaming, The AT2020 can be used for a lot of different applications, such as However, since it’s a condenser microphone, I wouldn’t recommend dropping it and to keep it from taking an accidental beating since condenser microphones are a bit more sensitive than dynamic mics and could break, so keep this in mind. When holding it in my hand it doesn’t feel like a cheap product at all, Just like all the Audio-Technica microphones, the AT2020 is extremely well The AT2020 is a cardioid condenser microphone, which means that it is going to need phantom power in order to work properly (48v exactly), like all condenser microphones, however, 99.9% of audio interfaces supply phantom power, so if you get one that’s at least fairly recent then it should work with this mic.
0 kommentar(er)
